2007-2013 Highlander Kluger · Service Manual BODY

SYSTEM DESCRIPTION

Troubleshooting · Vehicles built from May 2007


POWER WINDOW CONTROL SYSTEM DESCRIPTION
  1. The power window control system controls the power window operation using the power window regulator motors. The main controls of this system are the power window regulator master switch, which is mounted on the driver side door, and the power window regulator switches, which are mounted on the passenger side door and rear doors. Operating a window switch results in electrical power being transmitted to the corresponding power window regulator motor.

  2. The power window control system has the following functions:

    Function
    Outline
    Manual up-and-down function
    Function that causes window to go up while power window switch is being pulled halfway up and to go down while pushed halfway down. Window stops as soon as the switch is released.
    Driver's door auto up-and-down function
    Function that enables window of driver's door to be fully opened or closed by one press of power window switch.
    Jam protection function
    Function that automatically stops power window and moves it downward if a foreign object gets jammed in door window during auto-up operation (driver door).
    Remote control function
    Function that allows power window master switch to control MANUAL up-and-down operations of front passenger door window and rear door windows.
    Key-off operation function
    Function that makes it possible to operate power window for approximately 45 seconds after the ignition switch is turned on (IG) or off, if either front door is not opened.
    Diagnosis
    Function that allows power window switch to make a diagnosis for failed section when power window switch detects a malfunction in power window system. Power window switch light comes on or blinks to inform driver.
    Fail-safe
    A fail-safe function to disable a part of power window functions if pulse sensor in power window motor has a malfunction.
    Driver's door auto up-and-down function and remote control function are disabled.

← SYSTEM DIAGRAM (from May 2007)HOW TO PROCEED WITH TROUBLESHOOTING (May 2007 – Jul 2008) →