2007-2013 Highlander Kluger · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT DOOR SCUFF PLATE

  1. B173224
    Disengage the 8 claws and guide, and remove the front door scuff plate LH.


3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

4. REMOVE REAR DOOR SCUFF PLATE

  1. B173228
    Disengage the 5 claws, 3 clips and guide, and remove the rear door scuff plate LH.


5. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

6. REMOVE LOWER CENTER PILLAR GARNISH

  1. B173230
    Disengage the 2 claws and 2 clips, and remove the lower center pillar garnish LH.


7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

  1. B170910
    Remove the bolt and disconnect the floor end of the front seat outer belt assembly.


8. REMOVE CENTER PILLAR GARNISH

  1. B173229
    Remove the screw and clip.

  1. Disengage the 2 guides and clip, and remove the center pillar garnish LH.


9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. B170905
    Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

  1. B170907
    Using a screwdriver, pull out the locking button in the direction shown by the arrow to release the lock, and disconnect the pretensioner connector as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. B170906
    Remove the 2 bolts and front seat outer belt assembly.


10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

  1. B170909
    Remove the 2 bolts and front shoulder belt anchor adjuster assembly.

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →