2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REPLACEMENT

Removal / installation · Vehicles built from May 2007

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE REAR WHEEL

2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for 2WD)

  1. C167785
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for 4WD)

  1. C165996
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


4. REMOVE REAR DISC

  1. C166438E01
    Put matchmarks on the rear disc and the axle hub.

  1. D028126
    Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.


5. REMOVE REAR AXLE HUB BOLT

  1. C165992E01
    Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.

  1. Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

    SST
    09628-10011  


6. INSTALL REAR AXLE HUB BOLT

  1. C165993E01
    Install a washer and nut to a new rear axle hub bolt as shown in the illustration.

  1. Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.


7. INSTALL REAR DISC

  1. C166438E01
    Align matchmarks and install the rear disc.

    NOTICE:
    When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout.


8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for 2WD)

  1. C167785
    Install the rear disc brake caliper assembly with the 2 bolts.

    Torque:
    78 N*m{ 795 kgf*cm , 57 ft.*lbf }


9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for 4WD)

  1. C165996
    Install the rear disc brake caliper assembly with the 2 bolts.

    Torque:
    78 N*m{ 795 kgf*cm , 57 ft.*lbf }


10. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }

← COMPONENTS (from May 2007)COMPONENTS (from May 2007) →