Component
|
Function
|
Door control transmitter
|
- Has LOCK, UNLOCK, PANIC and GLASS HATCH OPEN switches*1.
- Has LOCK, UNLOCK switches.
- Has LOCK, UNLOCK, and GLASS HATCH OPEN switches.*2
- Has LOCK, UNLOCK, GLASS HATCH OPEN and POWER BACK DOOR switches.*3
- Transmits weak radio waves (recognition codes and function codes) to the door control receiver.
- Illuminates the indicator light (LED) during transmission.
|
Door control receiver
|
Receives weak radio waves (recognition codes and function codes) and outputs them as code data to the main body ECU.
|
- Front door courtesy light switch
- Rear door courtesy light switch
- Back door courtesy light switch
|
Turns on when a door is opened and turns off when it is closed. Outputs door status codes (open or closed) to the main body ECU.
|
Unlock warning switch
|
Detects if the key is inserted in the ignition key cylinder or not.
|
Door lock position switch
|
Transmits the door lock positions of each door to the main body ECU.
|
Main body ECU
|
Sends wireless door lock control signals in response to the code data from the door control receiver and signals from each switch.
|
Function
|
Operation
|
All door lock
|
Pressing the LOCK switch locks all doors.
|
All door unlock
|
Pressing the UNLOCK switch unlocks all doors.
|
Automatic lock
|
If none of the doors is opened within 30 seconds after they are unlocked by the wireless door lock control, all the doors will lock again automatically.
|
Panic alarm*1
|
Pressing the PANIC switch of the transmitter for longer than about 0.8 seconds causes the following alarms to activate:
- Sounds the horn and security horn.
- Flashes the hazard lights, headlights, and taillights.
- Illuminates the front interior light (when the switch is in the DOOR position).
While the panic alarm is operating, pressing any switch of the transmitter cancels the alarm operation.
|
Glass hatch open operation*2
|
Pressing the GLASS HATCH OPEN switch of the transmitter for longer than about 0.8 seconds opens the glass hatch.
|
Power back door open/close operation*3
|
Pressing the POWER BACK DOOR switch of the transmitter for longer than about 0.8 seconds opens or closes the back door.
|
Answer back
|
- When the doors are locked by wireless operation, the hazard warning lights flash once, and wireless door lock buzzer*1 sounds once.
- When the doors are unlocked by wireless operation, the hazard warning lights flash twice and wireless door lock buzzer*1 sounds twice.
- When the glass hatch is opened by wireless operation, the wireless door lock buzzer*1 sounds once.
|
Door ajar warning*1
|
The buzzer sounds when the LOCK switch is pressed when any of the doors are ajar, and it sounds for 10 seconds continuously. The buzzer stops when all doors are closed or the UNLOCK switch is pressed.
|
Illuminated entry
|
When all the doors are locked, pressing UNLOCK causes the interior lights to come on simultaneously with the unlock operation.
|
Self-diagnostic mode
|
The following are ways to enter the self-diagnostic mode:
- If the door control receiver receives normal radio waves from the door control transmitter when the system is in diagnostic mode, it flashes the interior light in a normal pattern that corresponds to the function of each switch.
- Read DTCs with the intelligent tester.
|
Transmitter recognition code registration
|
Enables the registration (writing and storing) of 6 types of transmitter recognition codes in the EEPROM that is contained in the door control receiver.
|