2007-2013 Highlander Kluger · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


CHECK PURGE VSV

  1. A175272
    Enter the following menus:

    1. Intelligent tester - Select: Powertrain / Engine and ECT / Active test / Activate the VSV for Evap Control.

  1. Disconnect the hose (connected to the canister) from the purge VSV.

  1. Start the engine.

  1. Using the tester, turn off the purge VSV (EVAP VSV: OFF).

  1. Use your finger to confirm that the purge VSV has no suction.

  1. Using the tester, turn on the purge VSV (EVAP VSV: ON).

  1. Use your finger to confirm that the purge VSV has suction.


INSPECT FUEL CUT OFF / RESTART RPM
  1. Increase the engine speed to at least 3500 rpm.

  1. Use a sound scope to check for injector operating sounds.

  1. Check that when the throttle lever is released, injector operation sound stops momentarily and then resumes (at 1400 rpm).

    Standard:
    Item
    Specified Condition
    Fuel injector restart rpm
    1400 rpm


VISUALLY INSPECT HOSE, CONNECTIONS AND GASKETS

  1. A094394
    Check for cracks, leaks or damage.

    HINT:
    Separation of the engine oil dipstick, oil filler cap, PCV hose, etc. may cause the engine to run improperly. Disconnection, looseness or cracks in the parts of the air induction system between the throttle body and cylinder head will allow air suction and cause the engine to run improperly.

← SYSTEM DIAGRAM (from May 2007)COMPONENTS (from May 2007) →