ON-VEHICLE CLEANING
Removal / installation · Vehicles built from May 2007
| 1. INSPECT RADIATOR ASSEMBLY |
Check that the radiator and condenser are not blocked with leaves, dirt, or insects. Clean the hose connections.

- If the fins are blocked, wash them with water or a steam cleaner.
- NOTICE:
- If the distance between the steam cleaner and core is too close, the fins may be damaged.
- Keep the following injection distance.
- Standard injection distance:
Injection Pressure
Specified Condition
2942 to 4903 kPa
(30 to 50 kgf/cm2, 427 to 711 psi)
300 mm (11.81 in.)
4903 to 7845 kPa
(50 to 80 kgf/cm2, 711 to 1138 psi)
500 mm (19.69 in.)
- If the fins are bent, straighten them with a screwdriver or pliers.
- Never apply water directly onto the electronic components.
- If the distance between the steam cleaner and core is too close, the fins may be damaged.
- If the fins are blocked, wash them with water or a steam cleaner.
Dry the fins with compressed air.
