2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

The Other Caller's Voice cannot be Heard, is too Quiet, or Distorted

Circuit diagnosis · Vehicles built from Jul 2010

INSPECTION PROCEDURE


1. CHECK CELLULAR PHONE
  1. Check if the other caller's voice can be heard properly.

    OK:
    Voice can be heard.

    HINT:
    The purpose of this step is to inspect the cellular phone when it is not connected to the vehicle.



NG
REPAIR OR REPLACE CELLULAR PHONE
OK


2. CHECK AUDIO AND VISUAL SYSTEM
  1. Check that sound from the audio system can be heard from the driver side speaker.

    OK:
    Sound from the audio system can be heard.

    HINT:
    If sound from the audio system cannot be heard, proceed to "No sound can be heard from speakers. (Audio is mute.)" in Problem Symptoms Table (Click here).



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK


3. CHECK SETTINGS
  1. Check that the received voice level setting on the cellular phone is not too low.

    OK:
    The received voice level setting is not too low.



NG
SET VOLUME TO HIGH
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cannot Call in a Certain Place (from Jul 2010)The Other Caller cannot Hear Your Voice, or Your Voice is too Quiet or Distorted (from Jul 2010) →