2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT SPEEDOMETER
  1. Check the operation.

    1. Using a speedometer tester (calibrated chassis dynamometer), check the speedometer indication according to the table below.

      Reference: km/h 
      Chassis dynamometer indication
      Acceptable range
      Data in ( ) is for reference
      20 km/h
      (21.0 to 25.0 km/h)
      40 km/h
      41.7 to 46.2 km/h
      60 km/h
      62.7 to 67.2 km/h
      80 km/h
      83.4 to 88.4 km/h
      100 km/h
      104.3 to 109.3 km/h
      120 km/h
      125.1 to 130.6 km/h
      140 km/h
      145.8 to 151.8 km/h
      160 km/h
      166.2 to 173.2 km/h
      180 km/h
      186.9 to 194.5 km/h
      200 km/h
      207.7 to 215.7 km/h
      220 km/h
      228.4 to 236.8 km/h
      240 km/h
      249.2 to 258.0 km/h

      NOTICE:
      Tire wear as well as over or under inflation will cause errors.

    2. Check the deviation from the acceptable range of the speedometer indication.

      Reference:
      Less than 0.5 km/h (0.3 mph)

      HINT:
      If the indication is not as specified, go to the problem symptoms table (Click here).


INSPECT TACHOMETER
  1. Connect the intelligent tester, and start the engine.

  1. Compare the test results with the tachometer indications.

    DC 13.5 V, at 25°C (77°F): 
    Intelligent Tester indication (rpm)
    Acceptable range
    Data in ( ) is for reference
    700
    630 to 770
    1,000
    (900 to 1100)
    2,000
    (1850 to 2150)
    3,000
    2800 to 3200
    4,000
    (3800 to 4200)
    5,000
    4800 to 5200
    6,000
    (5750 to 6250)
    7,000
    6700 to 7300
    8,000
    (7700 to 8300)

    HINT:
    If the indication is not as specified, go to the problem symptoms table (Click here).

← ON-VEHICLE INSPECTION (Aug 2008 – Jun 2010)B1500 Fuel Sender Open Detected (May 2007 – Jul 2008) →