P0717 Turbine Speed Sensor Circuit No Signal
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
This sensor detects the rotation speed of the input turbine. By comparing the input turbine speed signal (NT) with the counter gear speed sensor signal (NC), the ECM detects the shift timing of the gears and appropriately controls the engine torque and hydraulic pressure according to various conditions. Thus, providing smooth gear shift.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0717 |
ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more: (1-trip detection logic) (a) Vehicle speed: 50 km/h (31 mph) or more (b) Park/neutral position switch (NSW (STAR) and R) is OFF (c) Speed sensor (NT): less than 300 rpm |
|
Check the waveform between terminals NT+ and NT- of the ECM connector.


| Terminal |
NT+ - NT- |
| Tool setting |
5 V/DIV, 0.5 ms/DIV |
| Vehicle condition |
Vehicle speed 20 km/h (12 mph) |
MONITOR DESCRIPTION
The NT terminal of the ECM detects a revolution signal from the speed sensor (NT) (input RPM). The ECM calculates a gearshift comparing the speed sensor (NT) with the speed sensor (NC).While the vehicle is operating in 2nd, 3rd, 4th or 5th gear in the shift position of D, if the input shaft revolution is less than 300 rpm *1although the output shaft revolution is more than 1000 rpm *2, the ECM detects the trouble, illuminates the MIL and stores the DTC.
*1: Pulse is not output or is irregularly output.
*2: The vehicle speed is 50 km/h (31 mph) or more.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT SPEED SENSOR INSTALLATION |
Check the speed sensor installation.

- OK:
- The installation bolt is tightened properly and there is no clearance between the sensor and transaxle case.
|
|
||||
| OK | |
| 2. INSPECT SPEED SENSOR (NT) |
Disconnect the speed sensor connector from the transaxle.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
20°C (68°F)
560 to 680 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
Connect the speed sensor connector.

Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B2-35 (NT+) - B2-27 (NT-)
20°C (68°F)
560 to 680 Ω
Measure the resistance according to the value(s) in the table below.
- Standard resistance (Check for short):
Tester Connection
Condition
Specified Condition
B2-35 (NT+) - Body ground
Always
10 kΩ or higher
B2-27 (NT-) - Body ground
|
|
||||
| OK | ||
| ||
