2007-2013 Highlander Kluger · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE ENGINE UNDER COVER ASSEMBLY

  1. A171849
    Remove the 2 bolts and engine under cover assembly RR.

  1. A171850
    Remove the 2 bolts, 2 screws, 5 clips and engine under cover assembly.


3. REMOVE NO. 1 ENGINE UNDER COVER

  1. A171855
    Remove the 6 bolts, 2 clips and No. 1 engine under cover.


4. REMOVE NO. 2 ENGINE UNDER COVER

  1. A171854
    Remove the 2 bolts and No. 2 engine under cover.


5. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


6. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

HINT:
(Click here)


7. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

  1. C091925
    Remove the 18 bolts, oil pan, and gasket.

    NOTICE:
    Some fluid will remain in the oil pan. Carefully remove the oil pan so that fluid remaining in the pan does not spill out.

  1. D030865E03
    Remove the 2 magnets from the oil pan.

  1. AT00103
    Examine particles in the pan.

    1. Collect any steel chips using the removed magnets. Look carefully at the chips and particles in the pan and on the magnets to see the type of wear which might be found in the transaxle.

      Result:
      Steel (magnetic):
      Wear of the bearing, gear, or plate
      Brass (non-magnetic):
      Wear of the bushing


8. DISCONNECT TRANSMISSION WIRE

  1. C091927E08
    Disconnect the 7 shift solenoid valve connectors.

  1. Remove the bolt and lock plate, and disconnect the ATF temperature sensor.


9. REMOVE TRANSMISSION WIRE

  1. D030866
    Disconnect the transmission wire connector.

  1. Remove the bolt and transmission wire.

  1. Remove the O-ring from the transmission wire.

← COMPONENTS (from Jul 2010)REMOVAL (Aug 2008 – Jun 2010) →