2007-2013 Highlander Kluger · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. INSPECT PACK CLEARANCE OF FORWARD CLUTCH

  1. D026715E01
    Using a dial indicator, measure the forward clutch pack clearance while applying and releasing compressed air (392 kgf/cm2, 4.0 kPa, 57 psi).

    Pack clearance:
    1.00 to 1.25 mm (0.0394 to 0.0492 in.)

    If the piston stroke is less than the minimum, the parts may be assembled incorrectly. Check and reassemble the parts again.
    If the clearance is not as specified, select another flange.

    HINT:
    There are 5 different thicknesses of flanges available.

    Flange thickness: mm (in.) 
    No.
    Thickness
    No.
    Thickness
    1
    3.00 (0.1181)
    4
    3.45 (0.1358)
    2
    3.15 (0.1240)
    5
    3.60 (0.1417)
    3
    3.30 (0.1299)
    -
    -


2. REMOVE FORWARD MULTIPLE DISC CLUTCH DISC

  1. D026753E01
    Using a screwdriver, remove the snap ring.

  1. D026754
    Remove the flange, 5 discs, and 5 plates from the input shaft assembly.


3. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D026418E01
    Place SST on the spring retainer and compress the return spring with a press.
    SST
    09387-00020  

  1. Using a snap ring expander, remove the snap ring.

    NOTICE:
    1. Stop the press when the spring seat is lowered 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove to prevent the spring seat from being deformed.
    2. Do not expand the snap ring excessively.

  1. D026709E05
    Remove the clutch balancer from the input shaft.

  1. D026708E01
    Remove the forward clutch return spring from the input shaft.


4. REMOVE FORWARD CLUTCH PISTON SUB-ASSEMBLY

  1. D003664
    Place the forward clutch drum onto the oil pump.

  1. Holding the forward clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the oil pump to remove the forward clutch piston.

    HINT:
    When the piston cannot be removed as it is slanted, blow air again with the protruding side pushed, or remove the piston using needle nose pliers with its tip taped.


5. REMOVE INPUT SHAFT OIL SEAL RING

  1. C056374
    Remove the input shaft oil seal ring from the input shaft.

← COMPONENTS (from May 2007)INSPECTION (from May 2007) →