2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

5C-40 Camera Picture Error

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signals from the camera cannot be transmitted.
  1. Television camera
  2. Wire harness
  3. Navigation receiver assembly

WIRING DIAGRAM

E150790E05

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - TELEVISION CAMERA)

  1. E141024E08
    Disconnect navigation receiver assembly connector E3.

  1. E150736E03
    Disconnect television camera connector S1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E3-24 (CA+) - S1-4 (CB+)
    Always
    Below 1 Ω
    E3-21 (CGND) - S1-3 (CGND)
    Below 1 Ω
    E3-22 (V+) - S1-2 (CV+)
    Below 1 Ω
    E3-23 (V-) - S1-1 (CV-)
    Below 1 Ω
    E3-24 (CA+) - Body ground
    10 kΩ or higher
    E3-21 (CGND) - Body ground
    10 kΩ or higher
    E3-22 (V+) - Body ground
    10 kΩ or higher
    E3-23 (V-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E153726E02
    Reconnect navigation receiver assembly connector E3.

  1. Measure the voltage of the camera.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E3-24 (CA+) - E3-21 (CGND)
    Ignition switch on (IG), shift lever in reverse position
    Approx. 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


3. INSPECT TELEVISION CAMERA ASSEMBLY
E150777E01
  1. Reconnect television camera connector S1.

  1. Check the waveform of the television camera using an oscilloscope.

    OK:
    Waveform is as shown in the illustration.

    Item
    Content
    Terminal No. (Symbols)
    S1-2 (CV+) - S1-1 (CV-)
    Tool
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch on (IG), shift lever in reverse position



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)


← 58-45 High Temperature (+ 80-45) (Aug 2008 – Jun 2010)5C-40 Camera Picture Error (Aug 2008 – Jun 2010) →