2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (w/ Radio Receiver)

  1. E151673E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 5
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the integration control and panel assembly.

  1. Connect the (+) lead from the battery to terminal 6 and the (-) lead to terminal 7.

  1. Check that the illumination of the switch comes on.

    OK:
    The illumination comes on.

    If the result is not as specified, replace the integration control and panel assembly.


INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Radio Receiver)

  1. E151673E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 5
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the integration control and panel assembly.

  1. Connect the (+) lead from the battery to terminal 6 and the (-) lead to terminal 7.

  1. Check that the illumination of the switch comes on.

    OK:
    The illumination comes on.

    If the result is not as specified, replace the integration control and panel assembly.


INSPECT NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)

  1. E151673E02
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 - 5
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the navigation receiver assembly.

  1. Connect the (+) lead from the battery to terminal 6 and the (-) lead to terminal 7.

  1. Check that the illumination of the switch comes on.

    OK:
    The illumination comes on.

    If the result is not as specified, replace the navigation receiver assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →