2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side and the LH side (Click here).


3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

  1. B172999
    Disengage the 3 claws.

  1. Disengage the 2 guides and remove the No. 2 instrument panel under cover sub-assembly.


4. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

  1. B168370
    Remove the 2 bolts <B> and 3 screws <F>.

  1. Disengage the 4 claws and 3 clips.

  1. Disconnect each connector and clamp, and remove the lower instrument panel sub-assembly.


5. REMOVE ECM
  1. Separate the harness connector (LHD).

  1. Disconnect the 5 ECM connectors.

  1. A171720E01
    Remove the wire harness clamp.

  1. Remove the 2 nuts, bolt and ECM.


6. REMOVE NO. 1 ECM BRACKET

  1. A171721E01
    Remove the 2 screws and No. 1 ECM bracket.


7. REMOVE NO. 2 ECM BRACKET

  1. A171722E01
    Remove the 2 screws and No. 2 ECM bracket.

← COMPONENTS (from Jul 2010)REMOVAL (Aug 2008 – Jun 2010) →