2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

Combination Meter ECU Communication Stop Mode

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
Combination Meter ECU Communication Stop Mode
  1. "Combination Meter" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Combination Meter ECU Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the combination meter
  2. Combination meter main wire or connector
  3. Combination meter

WIRING DIAGRAM

C152889E05
C170366E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.


1. CHECK FOR OPEN IN CAN NO. 1 BUS WIRE (COMBINATION METER MAIN BUS WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the combination meter connector.

  1. C109571E21
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-25 (CANH) - E1-26 (CANL)
    Ignition switch off
    108 to 132 Ω



NG
REPAIR OR REPLACE CAN BUS MAIN WIRE OR CONNECTOR (COMBINATION METER MAIN BUS WIRE)
OK


2. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
  1. Disconnect the combination meter connector.

  1. C109571E22
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-20 (ES) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E1-1 (IG+) - Body ground
    Ignition switch on (IG)
    10 to 14 V
    E1-21 (B) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Main Body ECU Communication Stop Mode (from Jul 2010)Combination Meter ECU Communication Stop Mode (Aug 2008 – Jun 2010) →