2007-2013 Highlander Kluger · Service Manual COMMUNICATION SYSTEM

Main Body ECU Communication Stop Mode

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

Detection Item
Symptom
Trouble Area
Main Body ECU Communication Stop Mode
  1. "Main body" is not displayed on "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Main Body ECU Communication Stop Mode" in "DTC combination table"
  1. Power source circuit of the main body ECU
  2. Main body ECU branch wire or connector
  3. Main body ECU

WIRING DIAGRAM

C170062E07

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If any doors need to be opened in order to check the connectors, open the doors and leave them open.

HINT:
  1. Operating the ignition switch, any other switches, or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  2. Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below will help determine the cause of the malfunction.


1. CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the main body ECU connector.

  1. C195604E05
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D8-5 (CANH) - D8-6 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (MAIN BODY ECU BRANCH WIRE)
OK


2. CHECK POWER SOURCE CIRCUIT (MAIN BODY ECU)
  1. Check the main body ECU power source circuit (Click here).



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)


← ECM Communication Stop Mode (from Jul 2010)Main Body ECU Communication Stop Mode (Aug 2008 – Jun 2010) →