2007-2013 Highlander Kluger · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY

  1. D026703E01
    Place SST on the return spring and compress the return spring with a press.
    SST
    09387-00060  

  1. Using a screwdriver, remove the snap ring.

  1. D026704E05
    Remove the 2nd brake piston return spring.


2. REMOVE 2ND BRAKE PISTON

  1. D026705
    Hold the 2nd brake piston and apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the 2nd brake cylinder to remove the 2nd brake piston.

    NOTICE:
    Hold the piston with a shop rag or a piece of cloth when removing the piston. Failure to do so may result in the piston jumping out from the cylinder.


3. REMOVE 2ND BRAKE PISTON O-RING

  1. D026706E02
    Remove the 2 O-rings from the 2nd brake piston.

← COMPONENTS (from May 2007)INSPECTION (from May 2007) →