2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1442/42 Air Inlet Damper Control Servo Motor Circuit

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The damper servo (air inlet control) sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air inlet control damper to the appropriate position, which controls the intake air settings (FRESH, FRESH / RECIRCULATION and RECIRCULATION).

HINT:
Confirm that there are no mechanical problems because this DTC can be set ifeither a damper link or damper is mechanically locked.
DTC No.
DTC Detection Condition
Trouble Area
B1442/42
Air inlet damper position does not change even if air conditioning amplifier operates air inlet damper control servo motor
  1. Air inlet control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier


WIRING DIAGRAM

E133419E10

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (A/I DAMP TARG PLS)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch on.

  1. Select the item below in the Data List, and read the value displayed on the intelligent tester.

    Data List / Air Conditioner: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    A/I Damp Targ Pls
    Air inlet damper target pulse /
    Min.: 0, Max.: 255
    RECIRCULATION: 7 (pulse)
    FRESH: 28 (pulse)
    -

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2. REPLACE AIR INLET CONTROL SERVO MOTOR

HINT:
Since the servo motor cannot be tested when it is removed from the vehicle, replace the servo motor with a normal one and check that the condition returns to normal.

OK:
Same problem does not occur.


NEXT


3. CHECK DTC OUTPUT
  1. Check for DTC.

    OK:
    DTC B1442/42 is not output.



NG
REPAIR OR REPLACE AIR CONDITIONING HARNESS
OK

END


← B1442/42 Air Inlet Damper Control Servo Motor Circuit (May 2007 – Jul 2008)B1442/42 Air Inlet Damper Control Servo Motor Circuit (from Jul 2010) →