B1451/51 Compressor Solenoid Circuit
Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
In this circuit, the compressor receives a refrigerant compression demand signal from the air conditioning amplifier.Based on this signal, the compressor changes the degree of refrigerant compression.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1451/51 |
Open or short in solenoid of externally changeable compressor circuit |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. READ VALUE USING INTELLIGENT TESTER (REG CTRL CURRNT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester main switch on.
Select the items below in the Data List, and read the value displayed on the intelligent tester.
Data List / Air Conditioner: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Reg Ctrl Currnt
Regulator control current /
Min.: 0 A
Max.: 0.997 A
Value changes between 0 A and 0.997 A in accordance with compressor and magnetic clutch operation
-
- OK:
- The display is as specified in the normal condition column.
- Result:
Result
Proceed to
NG
A
OK (Checking from PROBLEM SYMPTOMS TABLE)
B
OK (Checking from DTC)
C
|
|
||||
|
|
||||
| A | |
| 2. INSPECT COMPRESSOR AND MAGNETIC CLUTCH |
Disconnect the compressor and magnetic clutch connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B44-3 (SOL+) - B44-6 (SOL-)
25°C (77°F)
10.1 to 11.1 Ω
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (COMPRESSOR AND MAGNETIC CLUTCH - AIR CONDITIONING AMPLIFIER) |
Disconnect the B44 compressor and magnetic clutch connector.

Disconnect the D33 amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B44-3 (SOL+) - D33-2 (SOL+)
Always
Below 1 Ω
B44-3 (SOL+) - Body Ground
Always
1 MΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (COMPRESSOR AND PULLEY - BODY GROUND) |
Disconnect the B44 compressor and magnetic clutch connector.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
B44-6 (SOL-) - Body Ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
