2007-2013 Highlander Kluger · Service Manual SECURITIES

Security Indicator Light Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The security indicator light blinks continuously due to a continuous signal received from the certification ECU (smart key ECU assembly) while in the armed state.

WIRING DIAGRAM

B178835E01

INSPECTION PROCEDURE

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key and ECU communication ID.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the tester on.

  1. Perform the Active Test according to the display on the tester.

    Smart Key (Certification ECU (Smart Key ECU Assembly)): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indic
    Security indicator light
    ON/OFF
    -

    OK:
    The security indicator light turns on and off according to the tester operation.



NG
Go to step 2
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - SECURITY INDICATOR LIGHT)

  1. B178825E01
    Disconnect the certification ECU (smart key ECU assembly) and security indicator light connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D36-2 (IND) - E13-2 (IND+)
    Always
    Below 1 Ω
    D36-2 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND)

  1. B164265E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E13-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SECURITY INDICATOR LIGHT (Click here)


← B279C Theft Deterrent System Presence Detection (from Jul 2010)Security Indicator Light Circuit (Aug 2008 – Jun 2010) →