2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSTALLATION

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL NO. 1 COOLER THERMISTOR

  1. E151029E01
    Install No. 1 cooler thermistor as shown in the illustration.
    Part
    Length
    A
    34.3 mm
    1.35 in.
    B
    20.9 mm
    0.82 in.
    C
    50 mm
    1.96 in.

    NOTICE:
    1. Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.
    2. When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
    3. After inserting the thermistor, do not apply excessive force to the wire.
    4. Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".


2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

  1. E151027
    Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces.

  1. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. E151026
    Install the No. 1 cooler evaporator sub-assembly.

  1. Engage the clamp.

  1. E151025
    Engage the 5 claws.

  1. Install the plate cover with the 6 screws.

  1. Connect the connector.


3. INSTALL COOLER EXPANSION VALVE

  1. E151024
    Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }


4. INSTALL BLOWER ASSEMBLY

  1. E151015
    Engage the 2 claws.

  1. Install the blower assembly with the 2 screws.

  1. Connect the connector.


5. INSTALL AIR CONDITIONING UNIT
(Click here)
← INSTALLATION (Aug 2008 – Jun 2010)COMPONENTS (May 2007 – Jun 2010) →