2007-2013 Highlander Kluger · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Click here.


2. SECURE ENGINE
  1. Secure the engine onto an engine stand with the bolts.

  1. A129635E01
    Remove the engine hangers.


3. REMOVE GENERATOR ASSEMBLY

  1. A170144
    Remove the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the generator connector from the generator assembly.

  1. Disconnect the connector from the compressor and magnetic clutch.

  1. Disconnect the 3 wire harness clamps.

  1. A170145
    Remove the 2 bolts, and then disconnect the bracket.

  1. A170146
    Remove the 2 bolts and the generator assembly.

  1. A170150
    Disconnect the wire harness clamp, and then remove the generator bracket.

  1. A170743
    Remove the bolt and the wire harness clamp bracket.


4. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

  1. A162789
    Remove the bolt, idler pulley cover plate and idler pulley sub-assembly.


5. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

  1. A161449
    Remove the 5 bolts and V-ribbed belt tensioner assembly.


6. REMOVE WATER PUMP PULLEY

  1. A128112E03
    Using SST, hold the water pump pulley.
    SST
    09960-10010   (09962-01000, 09963-00700)

  1. Remove the 4 bolts and water pump pulley.


7. REMOVE WATER INLET HOUSING

  1. A133375E04
    Disconnect the water hose.

  1. Remove the 2 bolts, nut and water inlet housing.

  1. A128120
    Remove the water inlet housing gasket and water outlet pipe O-ring.


8. REMOVE WATER PUMP ASSEMBLY

  1. A094889
    Remove the 16 bolts, water pump assembly and water pump gasket.

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →