2007-2013 Highlander Kluger · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT FUEL INJECTOR ASSEMBLY

A175689
  1. Inspect the injector resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      1-2
      Always
      11.6 to 12.4 Ω at 20°C (68°F)

      If the resistance is not as specified, replace the injector.

  1. Inspect the injection volume.

    CAUTION:
    This test involves high-pressure fuel and electricity. Take every precaution regarding the safe handling of both fuel and electricity. Perform this test in a safe area, and avoid any sparks or flames. Do not smoke.


    1. A088228E15
      Install the fuel tube connector to SST (hose), then connect the tube connector to the fuel pipe (vehicle side).
      SST
      09268-31013   (09268-41500, 90467-13001, 95336-08070)

      NOTICE:
      Do not scratch or allow any foreign matter on the connection between the fuel tube connector and the pipe, as they are sealed with the O-ring on the SST connector.

    2. Install the O-ring to the fuel injector.

    3. A250987E01
      Connect SST (adaptor and hose) to the injector, and hold the injector and union with SST (clamp).
      SST
      09268-31013   (09268-41141, 09268-41410, 90467-13001, 95336-08070)

    4. Put the injector into the graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector that will contain gasoline spray.

    5. Operate the fuel pump (Click here).

    6. A075915E12
      Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
      SST
      09842-30080  

      Volume:
      84 to 100 cm3 (5.1 to 6.0 cu in.) in 15 seconds

      Difference between each injector:
      16 cm3 (0.98 cu in.) or less

      If the injection volume is not as specified, replace the injector.

  1. A132391
    Check for leaks.

    1. Disconnect the tester probes of SST (wire) from the battery and check for fuel leaks from the injector.

      Fuel drop:
      1 drop or less in 16 minutes

← INSPECTION (May 2007 – Jul 2008)INSPECTION (from Jul 2010) →