ON-VEHICLE INSPECTION
Inspection · Vehicles built May 2007 – Jul 2008
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
- HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
| SEPARATE REAR FLEXIBLE HOSE
|
 |
- Remove the bolt and separate the rear flexible hose from the rear shock absorber with coil spring.
| SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Remove the 2 bolts and separate the rear disc brake caliper assembly.
- NOTICE:
- Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
| REMOVE REAR DISC
|
 |
- Put matchmarks on the rear disc and the axle hub.
- Release the parking brake and remove the rear disc.
- HINT:
- If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.
| INSPECT REAR AXLE HUB BEARING LOOSENESS |
 |
- Using a dial indicator, check for looseness near the center of the axle hub.
- Maximum looseness:
- 0 mm (0 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.
| INSPECT REAR AXLE HUB RUNOUT |
 |
- Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
- Maximum runout:
- 0.08 mm (0.0031 in.)
- NOTICE:
- Ensure that the dial indicator is set perpendicular to the measurement surface.
If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.
| INSTALL REAR DISC
|
 |
- Align matchmarks and install the rear disc.
- NOTICE:
- When replacing the rear disc with a new one, select the installation position where the rear disc has minimal runout.
| INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
|
 |
- Install the rear disc brake caliper assembly with the 2 bolts.
-
Torque:
- 78 N*m{
795 kgf*cm
, 57 ft.*lbf
}
| INSTALL REAR FLEXIBLE HOSE
|
 |
- Install the rear flexible hose to the rear shock absorber with coil spring with the bolt.
-
Torque:
- 19 N*m{
194 kgf*cm
, 14 ft.*lbf
}
- NOTICE:
- Do not twist the rear flexible hose when installing it.
| INSTALL REAR WHEEL |
 |
-
Torque:
- 103 N*m{
1050 kgf*cm
, 76 ft.*lbf
}