2007-2013 Highlander Kluger · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR WHEEL

3. SEPARATE REAR FLEXIBLE HOSE

  1. C167792
    Remove the bolt and separate the rear flexible hose from the rear shock absorber with coil spring.


4. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

  1. C167785
    Remove the 2 bolts and separate the rear disc brake caliper assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.


5. REMOVE REAR DISC

  1. C166438E01
    Put matchmarks on the rear disc and the axle hub.

  1. D028126
    Release the parking brake and remove the rear disc.

    HINT:
    If the disc cannot be removed easily, turn and press firmly the shoe adjuster until the wheel comes free.


6. SEPARATE REAR SPEED SENSOR WIRE

  1. C167422
    Using a screwdriver, disconnect the connector from the rear speed sensor.

    NOTICE:
    Be careful not to damage the rear speed sensor.


7. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

  1. C167786
    Remove the 4 bolts and the rear axle hub and bearing assembly.

    NOTICE:
    Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.


8. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

  1. C165998
    Remove the bolt and the nut, and separate the No. 3 parking brake cable assembly.


9. REMOVE REAR STRUT ROD ASSEMBLY

  1. C167803
    Remove the 2 bolts, the 2 nuts, and the rear strut rod assembly.

    NOTICE:
    Since stopper nuts are used, loosen the bolts.


10. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY

  1. C167788
    Loosen the 2 bolts.

    NOTICE:
    Since stopper nuts are used, loosen the bolts.

  1. C167787
    Remove the 2 bolts and 2 nuts, and separate the rear axle carrier sub-assembly from the rear shock absorber with coil spring.

  1. C167789
    Remove the 2 bolts, the 2 nuts, and the rear axle carrier sub-assembly.

← REMOVAL (Aug 2008 – Jun 2010)INSTALLATION (May 2007 – Jul 2008) →