2007-2013 Highlander Kluger · Service Manual ENGINE

CHECK FOR INTERMITTENT PROBLEMS

Troubleshooting · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

HINT:
  1. Intelligent tester only:
    Inspect the vehicle's ECM using check mode. Intermittent problems are easier to detect with the intelligent tester when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which has a higher sensitivity to malfunctions than normal mode (default) using 2 trip detection logic.

  1. Clear the DTCs (Click here).
  2. Switch the ECM from normal mode to check mode using the intelligent tester (Click here).
  3. Perform a simulation test (Click here).
  4. Check the connector(s) and terminal(s) (Click here).
  5. Wiggle the harness(es) and connector(s) (Click here).
← HOW TO PROCEED WITH TROUBLESHOOTING (from Jul 2010)CHECK FOR INTERMITTENT PROBLEMS (Aug 2008 – Jun 2010) →