2007-2013 Highlander Kluger · Service Manual BODY

REPAIR

Removal / installation · Vehicles built from May 2007


1. REPAIR DEFOGGER WIRE

B063722E05
  1. Clean the broken wire tips with grease, wax and silicone remover.

  1. Place masking tape along both sides of the wire.

  1. Thoroughly mix the repair agent.

    Dupont paste:
    No. 4817 or equivalent

  1. B063723E03
    Using a fine tip brush, apply a small amount of the agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not repair the defogger wire again for at least 24 hours.

← ON-VEHICLE INSPECTION (from May 2007)COMPONENTS (May 2007 – Jun 2010) →