2007-2013 Highlander Kluger · Service Manual ENGINE

B2275 STSW Monitor Malfunction

Diagnostic trouble codes · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output if there is an open, short, or any other problem in the engine start request output circuit inside the main body ECU or in the external circuit.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2275
STSW output circuit (engine starting request signal circuit) inside main body ECU or other related circuit is malfunctioning
  1. Main body ECU (Instrument panel junction block)
  2. ECM
  3. Wire harness or connector

WIRING DIAGRAM

B176786E05

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, turn the engine switch on (IG) and depress the brake pedal. After 15 seconds have elapsed, check if the trouble occurs again.

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
Go to step 2
OK

USE SYMPTOM METHOD TO CHECK (Click here)

2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - ECM)

  1. Disconnect the D9 ECU connector.B176966E02

  1. Disconnect the B3 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D9-4 (STSW) - B3-12 (STSW)
    Always
    Below 1 Ω
    D9-4 (STSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT MAIN BODY ECU

  1. B138004E19
    Reconnect the D9 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D9-4 (STSW) - Body ground
    Brake pedal depressed, Engine switch hold on (ST)
    Output voltage at terminal AM1 or AM2 is -2 V or more.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

REPLACE ECM (Click here)


← B2275 STSW Monitor Malfunction (May 2007 – Jul 2008)B2275 STSW Monitor Malfunction (from Jul 2010) →