2007-2013 Highlander Kluger · Service Manual ENGINE

B2277 Detecting Vehicle Submersion

Diagnostic trouble codes · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010

DESCRIPTION

This DTC is output if the submersion circuit monitor inside the main body ECU detects that the vehicle is submerged in water.

HINT:
If the main body ECU is replaced with a new one while the negative (-) battery terminal is connected, the power source mode will be in IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedure for the engine immobiliser system.

DTC No.
DTC Detection Condition
Trouble Area
B2277
Submersion circuit monitor inside main body ECU detects that vehicle is submerged in water
Main body ECU (Instrument panel junction block)

INSPECTION PROCEDURE


1. CHECK FOR WATER DAMAGE
  1. Check the main body ECU, peripheral components, and wire harnesses for traces of water.

    OK:
    There are no traces of water.



NG
TAKE APPROPRIATE MEASURES AGAINST CAUSE OF WATER DAMAGE AND REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK


2. CHECK DTC OUTPUT
  1. Delete the DTCs (Click here).

    HINT:
    After all DTCs are cleared, check if the trouble occurs again 270 to 330 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    No DTC is output.



NG
REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)
OK

USE SYMPTOM METHOD TO CHECK (Click here)


← B2276 ACCR Signal Circuit Malfunction (from Jul 2010)B2277 Detecting Vehicle Submersion (from Jul 2010) →