2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Taillight Relay Circuit

Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

  1. The main body ECU receives the light control switch TAIL signal to control the taillight relay.
  2. When the light control switch is in the AUTO position, the main body ECU receives the ambient light level signal from the automatic light control sensor to control the taillight relay.

WIRING DIAGRAM

E151700E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester on.

  1. Select the following menu items: Body Electrical / Main Body / Active Test.

  1. Check that the relay operates.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Taillight Relay
    Taillight relay
    ON/OFF
    -

    OK:
    Taillight relay operates. (Taillights illuminate.)



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. INSPECT FUSE (TAIL)
  1. Remove the TAIL fuse from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    TAIL fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. INSPECT TAILLIGHT RELAY (TAIL)

  1. A087121E11
    Remove the taillight relay from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Apply the battery voltage between terminals 1 and 2
    Below 1 Ω
    3 - 4
    Voltage is not applied between terminals 1 and 2
    Below 1 Ω
    Apply the battery voltage between terminals 1 and 2
    10 kΩ or higher



NG
REPLACE TAILLIGHT RELAY
OK


4. INSPECT MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)

  1. E151667E01
    Measure the voltage between the loading slot of the TAIL fuse and body ground.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    TAIL fuse terminal - Body ground
    Light control switch OFF → TAIL
    Below 1 V → 11 to 14 V



NG
Go to step 5
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (FUSE - BODY GROUND)

5. CHECK HARNESS AND CONNECTOR (BATTERY - INSTRUMENT PANEL JUNCTION BLOCK)

  1. E121505E04
    Disconnect the 1A instrument panel junction block connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1A-1 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)


← Taillight Relay Circuit (May 2007 – Jul 2008)Taillight Relay Circuit (from Jul 2010) →