2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

IG Power Source Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This is the main power source supplied to the air conditioning amplifier when the ignition switch is on (IG). This power source is used for operating components, such as the air conditioning amplifier and servo motors.

WIRING DIAGRAM

E153375E09

INSPECTION PROCEDURE


1. INSPECT FUSE (A/C NO. 2)
  1. Remove the A/C NO. 2 fuse from the instrument panel junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A/C NO. 2 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)

  1. E143742E95
    Disconnect the D33 amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D33-1 (IG+) - Body ground
    Ignition switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND)

  1. E153377E37
    Disconnect the D33 and D34 amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D33-14 (GND) - Body ground
    Always
    Below 1 Ω
    D34-20 (GND2)* - Body ground
    Always
    Below 1 Ω

    HINT:
    *: w/ Rear Air Conditioning



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← IG Power Source Circuit (Aug 2008 – Jun 2010)Back-up Power Source Circuit (May 2007 – Jul 2008) →