2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

Back-up Power Source Circuit

Circuit diagnosis · Vehicles built from Jul 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

This is the back-up power source circuit for the air conditioning amplifier. Power is supplied even when the ignition switch is turned off and is used for functions such as the diagnostic trouble code memory.

WIRING DIAGRAM

E174119E08

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-B NO. 1)
  1. Remove the ECU-B NO. 1 fuse from the engine room relay block and junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-B NO. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)

  1. E153377E35
    Disconnect the D33 and D34 amplifier connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D33-21 (B) - Body ground
    Always
    11 to 14 V
    D34-24 (+B2)* - Body ground
    Always
    11 to 14 V

    HINT:
    *: w/ Rear Air Conditioning



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BODY GROUND)

  1. E153377E36
    Disconnect the D33 and D34 amplifier connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D33-14 (GND) - Body ground
    Always
    Below 1 Ω
    D34-20 (GND2)* - Body ground
    Always
    Below 1 Ω

    HINT:
    *: w/ Rear Air Conditioning



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Back-up Power Source Circuit (Aug 2008 – Jun 2010)LIN Communication Circuit (May 2007 – Jul 2008) →