Heater Control Panel Power Source Circuit
Circuit diagnosis · Vehicles built from May 2007
DESCRIPTION
Battery voltage is supplied to the heater control panel (A/C control assembly) through the A/C No. 2 fuse.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (IG+ - BODY GROUND) |
Disconnect the connector from the heater control panel.

Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Condition
Specified Condition
E8-2 (IG+) - Body ground
Ignition switch on (IG)
11 to 14 V
E8-2 (IG+) - Body ground
Ignition switch off
Below 1 V
- Result:
Result
Proceed to
OK
A
NG (without Smart entry and start system)
B
NG (with Smart entry and start system)
C
|
|
||||
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (GND - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Condition
Specified Condition
E8-10 (GND) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
