Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)
LIN Communication Circuit
Circuit diagnosis · Vehicles built Aug 2008 – Jun 2010
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010
DESCRIPTION
The operation signal of a switch etc. is exchanged between terminal LIN1 of the air conditioning control assembly and terminal LIN1 of the air conditioning amplifier. WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK AIR CONDITIONING SYSTEM (OPERATION)
Result:
Result
Proceed to
Front air conditioning control malfunctions
A
Rear air conditioning control malfunctions
B
B
A
2. CHECK HARNESS AND CONNECTOR (A/C CONTROL ASSEMBLY - AIR CONDITIONING AMPLIFIER)
Disconnect the connector from the air conditioning control assembly.
Disconnect the connector from the air conditioning amplifier.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
D33-37 (LIN1) - E8-5 (LIN1)
Always
Below 1 Ω
D33-37 (LIN1) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )
3. CHECK HARNESS AND CONNECTOR (REAR A/C CONTROL ASSEMBLY - AIR CONDITIONING AMPLIFIER)
Disconnect the connector from the rear air conditioning control assembly.
Disconnect the connector from the air conditioning amplifier.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
D34-13 (BLIN) - R1-5 (MPX-)
Always
Below 1 Ω
D34-13 (BLIN) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here )