2007-2013 Highlander Kluger · Service Manual RESTRAINTS

INSTALLATION

Removal / installation · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
  1. The nuts must not be reused.
  2. Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.

  1. C223333
    Install the front seat airbag assembly with 2 new nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Engage the 2 clamps to connect the wire harness.


2. INSTALL FRONT SEATBACK COVER WITH PAD
  1. Temporarily install the front seatback cover with pad to the front seat frame assembly with adjuster.

  1. B172866
    Engage the 4 claws and install the 2 front seat headrest supports.

  1. C223334E01
    Engage the hook and install the separate type front seatback cover bracket with the nut.

    Torque:
    5.6 N*m{ 57 kgf*cm , 50 in.*lbf }

    NOTICE:
    1. For vehicles with side airbags, the side airbags may not activate normally unless the front seatback cover is securely installed.
    2. Check that the strap is not twisted after installing the bracket.
    3. Install the bracket securely.

  1. B174630
    Engage the 2 hooks.

  1. C226431E01
    Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.

  1. C223331
    Close the 2 fasteners.

  1. B174635E01
    Using hog ring pliers, install the front seatback cover with pad with 3 new hog rings.

    NOTICE:
    1. Be careful not to damage the cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.

  1. w/ Seat Heater:

    1. C223330
      Connect the connector and engage the 2 clamps.


3. INSTALL AIRBAG WIRE HARNESS (for Manual Seat)

  1. C223328
    Engage the claw and 4 clamps to install the airbag wire harness.

  1. B172849
    Engage the 2 hooks.


4. INSTALL AIRBAG WIRE HARNESS (for Power Seat)

  1. C223329
    Engage the claw and 4 clamps to install the airbag wire harness.

  1. B172849
    Engage the 2 hooks.


5. INSTALL FRONT SEAT ASSEMBLY
for Manual Seat: (Click here)
for Power Seat: (Click here)

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


7. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat)

8. INSPECT SRS WARNING LIGHT

HINT:
Check the SRS warning light (Click here).

← REMOVAL (from Jul 2010)INSTALLATION (Aug 2008 – Jun 2010) →