2007-2013 Highlander Kluger · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

  1. B172931
    Disengage the claw and clip, and remove the front door lower frame bracket garnish.


2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

  1. B172920E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.


3. REMOVE FRONT ARMREST UPPER BASE PANEL

  1. B172922E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 7 claws and clip, and remove the front armrest upper base panel.

  1. Disconnect the connector.


4. REMOVE ASSIST GRIP COVER

  1. B174183E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the 4 claws and remove the assist grip cover.


5. REMOVE COURTESY LIGHT ASSEMBLY

  1. B172929E01
    Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.

  1. Disconnect the connector.


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

  1. B172932
    Remove the 3 screws.

  1. B172933
    Using a clip remover, disengage the 9 clips.

  1. Disengage the 5 claws and separate the front door trim board sub-assembly from the front door inner glass weatherstrip.

  1. B172934
    Disengage the 2 clamps.

  1. Disconnect the front door lock remote control cable and front door inside locking cable.

  1. Disconnect the connector.


7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER

  1. B173464E01
    Disconnect the connector and clamp.

  1. Disengage the clip.

  1. B173465
    Remove the 3 nuts.

  1. Disengage the claw and remove the outer rear view mirror assembly with cover.


8. REMOVE OUTER MIRROR GLASS (w/o Heater)

  1. B173445E01
    Apply protective tape to the bottom of the visor of the door mirror.

  1. Push the upper part of the mirror surface and tilt it.

  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws.

  1. B173446
    Disengage the 2 claws at the upper part of the outer mirror.

  1. Remove the outer mirror glass.


9. REMOVE OUTER MIRROR GLASS (w/ Heater)

  1. B173445E01
    Apply protective tape to the bottom of the visor of the door mirror.

  1. Push the upper part of the mirror surface and tilt it.

  1. Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws.

  1. B173446
    Disengage the 2 claws at the upper part of the outer mirror.

  1. B173447
    Disconnect the connectors and remove the outer mirror glass.


10. REMOVE OUTER MIRROR COVER

  1. B173461
    Disengage the 8 claws and remove the outer mirror cover from the outer rear view mirror assembly with cover.

← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →