TERMINALS OF ECU
System information · Vehicles built from Jul 2010
Versions by build date: May 2007 – Jun 2010 from Jul 2010
| CHECK MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the main body ECU (instrument panel junction block) connectors.


Measure the resistance and voltage between each terminal of the wire harness side connectors and body ground.
Tester Connection
Wiring Color
Terminal Description
Condition
Specified Condition
D6-7 (RCTY) - Body ground
GR - Body ground
Rear courtesy light switch RH input
Rear door RH CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
D6-21 (PCTY) - Body ground
SB*1 - Body ground
Passenger side courtesy light switch input
Passenger side door CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
G*2 - Body ground
D6-25 (BCTY) - Body ground
L - Body ground
Back door courtesy light switch input
Back door CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
D7-16 (HCTY) - Body ground
L - Body ground
Engine hood courtesy switch
Engine hood CLOSED (OFF) → OPEN (ON)
Below 1 Ω → 10 kΩ or higher
D7-24 (DCTY) - Body ground
G*1 - Body ground
Driver side door courtesy light switch input
Driver side door CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
SB*2 - Body ground
D9-8 (GHSW) - Body ground
O - Body ground
Glass hatch courtesy switch
Glass hatch CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
D9-5 (KSW) - Body ground
GR - Body ground
Unlock warning switch input
No key in ignition key cylinder (OFF) → Key inserted (ON)
10 kΩ or higher → Below 1 Ω
1A-1 (ACC) - Body ground
B - Body ground
Ignition power supply (ACC signal)
Ignition switch ACC → OFF
11 to 14 V → Below 1 V
1A-1 (IG) - Body ground
B - Body ground
Ignition power supply (IG signal)
Ignition switch ON → OFF
11 to 14 V → Below 1 V
1D-16 (ALTB) - Body ground
W - Body ground
+B (power system alternator system) power supply
Always
11 to 14 V
1F-10 (GND1) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
1D-10 (BECU) - Body ground
W - Body ground
+B power supply
Always
11 to 14 V
1M-9 (GND2) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
1O-7 (LCTY) - Body ground
B - Body ground
Rear courtesy light switch LH input
Rear door LH CLOSED (OFF) → OPEN (ON)
10 kΩ or higher → Below 1 Ω
- HINT:
- *1: for LHD
- *2: for RHD
- If the result is not as specified, there may be a malfunction on the wire harness side.
- *1: for LHD
Reconnect the main body ECU (instrument panel junction block) connectors.
Measure the voltage between each terminal of the wire harness side connectors and body ground.
If the result is not as specified, the main body ECU (instrument panel junction block) may have a malfunction.Tester Connection
Wiring Color
Terminal Description
Condition
Specified Condition
D9-6 (SH) - Body ground
W - Body ground
Security horn drive
Security horn is sounding
(Theft deterrent system is in alarm sounding state)
Pulse generation
(Below 1 V ← → 12 V)
D8-4 (HAZ) - Body ground
O - Body ground
Turn signal flasher relay signal
System is in alarm sounding state
Below 1 V
D9-4 (IND) - Body ground
B - Body ground
Security indicator light output
Security indicator light is on
(It lights up only in arming preparation state or alarm sounding state. It flashes when immobiliser is operating.)
3 to 6 V
1D-11 (HORN) - Body ground
GR - Body ground
Vehicle horn drive
Vehicle horn is sounding
(Theft deterrent system is in alarm sounding state)
Pulse generation
(Below 1 V ← → 12 V)