2007-2013 Highlander Kluger · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built Aug 2008 – Jun 2010

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

  1. C166039
    Depress the brake pedal and hold it.

  1. Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.

    HINT:
    Put a piece of cloth or equivalent into the inside of the universal joint cover so that the boot does not touch the inside of the universal joint cover.

  1. C166040E01
    Place matchmarks on the rear propeller shaft and rear drive pinion flange sub-assembly.

  1. Remove the 4 nuts, 4 bolts and 4 washers.

  1. C166041
    Remove the 4 bolts and 4 adjusting shims.

  1. C166073
    Using a brass bar and a hammer, remove the propeller shaft with center bearing shaft assembly.

  1. C166042E01
    Insert SST into the transfer to prevent oil leakage.
    SST
    09325-20010  


2. REMOVE REAR DIFFERENTIAL FILLER PLUG

  1. C166706
    Using a hexagon wrench (10 mm), remove the rear differential filler plug and rear differential filler plug gasket.


3. REMOVE REAR DIFFERENTIAL DRAIN PLUG

  1. C166707
    Using a hexagon wrench (10 mm), remove the rear differential drain plug and rear differential drain plug gasket, and drain the oil.


4. REMOVE REAR DRIVE PINION NUT

  1. C168605E01
    Using SST and a hammer, unstake the staked part of the rear drive pinion nut.
    SST
    09930-00010  

  1. C167081E01
    Using SST to hold the rear drive pinion companion flange sub-assembly, remove the rear drive pinion nut.
    SST
    09330-00021  


5. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY

  1. C167083E01
    Using SST, remove the rear drive pinion companion flange sub-assembly.
    SST
    09950-30012   (09951-03010, 09953-03010, 09954-03010, 09955-03030, 09956-03020)


6. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL

  1. C167085E01
    Using SST, remove the rear differential carrier oil seal.
    SST
    09308-10010  


7. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER

8. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING

  1. G024179E01
    Using SST, remove the rear drive pinion front tapered roller bearing.
    SST
    09556-22010  


9. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER
← REMOVAL (May 2007 – Jul 2008)REMOVAL (from Jul 2010) →