2007-2013 Highlander Kluger · Service Manual DRIVE LINE

PRECAUTION

Precautions · Vehicles built from May 2007


1.NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH
  1. When removing and installing the front drive shaft assembly RH in a 4WD vehicle, be sure to first drain all the transaxle oil and transfer oil. If removal and installation are carried out without draining these oils, the transfer oil will flow into the transaxle side. Extensive cleaning will be required if the two oils mix.

← INSTALLATION (from May 2007)PROBLEM SYMPTOMS TABLE (May 2007 – Jul 2008) →