2007-2013 Highlander Kluger · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from May 2007


1. REMOVE POSITION INDICATOR HOUSING ASSEMBLY

  1. C168446
    Separate the connector and 2 wire harness clamps from the shift lock control unit.

  1. G028933E01
    Using a screwdriver, release the stopper.

  1. Using a screwdriver, disengage the locking lug of terminals (4) and (8), and pull the terminals out from the rear of the connector.

  1. C168447
    Separate the wire harness clamp from the shift lock control unit.

  1. Disengage the 4 claws and remove the position indicator housing from the shift lock control unit.


2. REMOVE POSITION INDICATOR HOUSING LOWER

  1. C168448
    Disengage the 4 claws and remove the position indicator housing lower from the position indicator housing.


3. REMOVE POSITION INDICATOR LIGHT GUIDE

  1. C168456
    Disengage the 4 claws and remove the position indicator light guide from the position indicator housing lower.


4. REMOVE INDICATOR LIGHT WIRE SUB-ASSEMBLY

  1. C168451
    Remove the indicator light wire sub-assembly from the position indictor light guide.


5. REMOVE POSITION INDICATOR LIGHT BULB
  1. Remove the bulb and cap from the indicator light wire socket.


6. REMOVE POSITION INDICATOR SLIDE COVER

  1. C168457
    Remove the position indicator slide cover from the position indicator housing lower.


7. REMOVE NO. 2 POSITION INDICATOR SLIDE COVER

  1. C168458
    Remove the position indicator slide cover from the No. 2 position indicator slide cover.

← REMOVAL (from Jul 2010)INSPECTION (from May 2007) →