2007-2013 Highlander Kluger · Service Manual TRANSMISSION

INSTALLATION

Removal / installation · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


1. INSTALL OIL WITH HOSE COOLER ASSEMBLY

  1. C167672
    Install the oil with hose cooler assembly with the bolt and the nut.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    HINT:
    After temporarily tightening the bolt, fully tighten the nut and then bolt.

  1. Connect the 2 oil cooler hoses and install the 2 hose clamps.


2. INSTALL FRONT BUMPER ASSEMBLY

HINT:
(Click here)


3. ADD AUTOMATIC TRANSAXLE FLUID

4. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT:
Drive the vehicle so that the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80°C (158 to 176°F)

  1. Park the vehicle on a level surface and set the parking brake.

  1. D025120E05
    With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to S1 and return to the P position.

  1. Take out the dipstick and wipe it clean.

  1. Put the dipstick back all the way.

  1. Take out the dipstick again and check that the fluid level is within the HOT range.
    If the fluid level is below the HOT range, add new fluid and recheck the fluid level.
    If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.
    If there are leaks, it is necessary to repair or replace O-rings, FIPGs, oil seals, plugs and/or other parts.


5. INSPECT FOR TRANSAXLE FLUID LEAK
← REMOVAL (from Jul 2010)INSTALLATION (from Jul 2010) →