2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Television Display Power Source Circuit

Circuit diagnosis · Vehicles built from May 2007

DESCRIPTION

This is the power source circuit of the television display assembly.

WIRING DIAGRAM

E153681E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY, BODY GROUND)
E154378E01
  1. Disconnect the television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Q13-12 (GND6) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Q13-16 (+B2) - Body ground
    Always
    11 to 14 V
    Q13-15 (ACC4) - Body ground
    Ignition switch on (ACC)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← A Remote Control System does not Operate (from May 2007)COMPONENTS (from May 2007) →