2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010

DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch.

WIRING DIAGRAM

E150789E04

INSPECTION PROCEDURE


1. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E141022E12
    Disconnect navigation receiver assembly connector E4.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E4-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever R position
    10 to 14 V
    E4-5 (REV) - Body ground
    Ignition switch on (IG)
    Shift lever any position except R
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)

  1. E150782E06
    Disconnect navigation receiver assembly connector E4 and park/neutral position switch connector B5.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E4-5 (REV) - B5-1 (RL)
    Always
    Below 1 Ω
    E4-5 (REV) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT PARK/NEUTRAL POSITION SWITCH

  1. E153722E01
    Disconnect park/neutral position switch connector B5.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B5-1 (RL) - B5-2 (RB)
    Shift lever R position
    Below 1 Ω
    B5-1 (RL) - B5-2 (RB)
    Shift lever any position except R
    10 kΩ or higher

    Result:
    Result
    Proceed to
    OK
    A
    NG (for U151E)
    B
    NG (for U151F)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151E) (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (for U151F) (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← TERMINALS OF ECU (from Jul 2010)Reverse Signal Circuit (Aug 2008 – Jun 2010) →