2007-2013 Highlander Kluger · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from May 2007


INSPECT STOP LIGHT CONTROL RELAY
  1. Remove the stop light control relay.

  1. C126459E07
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Voltage is not applied between terminals 1 and 2
    Below 1 Ω
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 4
    Voltage is applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the value is not as specified, replace the stop light control relay.

← INSTALLATION (from Jul 2010)PRECAUTION (from May 2007) →