2007-2013 Highlander Kluger · Service Manual HEATER & AIR CONDITIONING SYSTEM

B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side)

Diagnostic trouble codes · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010

DESCRIPTION

The air mix control servo motor sends pulse signals to indicate the damper position to the air conditioning amplifier. The air conditioning amplifier activates the motor (normal or reverse) based on these signals to move the air mix damper (driver side) to the appropriate position. This adjusts the amount of air passing through the heater core after passing the evaporator and controls the temperature of the blown air.

HINT:
Confirm that there are no mechanical problems because this DTC can be set if either a damper link or damper is mechanically locked.

DTC No.
DTC Detection Condition
Trouble Area
B1446/46
Air mix damper position does not change even if air conditioning amplifier operates air mix damper control servo motor
  1. Air mix control servo motor
  2. Air conditioning harness
  3. Air conditioning amplifier

WIRING DIAGRAM

E133419E08

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (AIR MIX SERVO TARG PULSE (D))
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the intelligent tester main switch on.

  1. Select the item below in the Data List, and read the value displayed on the intelligent tester.

    Data List / Air Conditioner: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Air Mix Pulse-D
    Driver side air mix control servo motor target pulse /
    Min.: 0, Max.: 255
    1. LHD:
      MAX. COLD: 5 (pulse)
      MAX. HOT: 103 (pulse)
    1. RHD:
      MAX. COLD: 105 (pulse)
      MAX. HOT: 7 (pulse)
    -

    OK:
    The display is as specified in the normal condition column.


    Result:
    Result
    Proceed to
    NG
    A
    OK (Checking from PROBLEM SYMPTOMS TABLE)
    B
    OK (Checking from DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER (Click here)
A


2. REPLACE AIR MIX CONTROL SERVO MOTOR
  1. Replace the air mix control servo motor (Click here).


NEXT


3. CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Check for DTC (Click here).

    OK:
    DTC B1446/46 is not output.



NG
REPAIR OR REPLACE AIR CONDITIONING HARNESS
OK

END (AIR MIX CONTROL SERVO MOTOR IS DEFECTIVE)


← B1443/43 Air Outlet Damper Control Servo Motor Circuit (from Jul 2010)B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) (Aug 2008 – Jun 2010) →