TERMINALS OF ECU
System information · Vehicles built from May 2007
| CHECK POWER STEERING ECU |


- HINT:
- As connector "z6" uses a lock lever, each terminal cannot be checked while the connector is still connected to the power steering ECU.
Terminal No. (Symbols)
Wiring Color
Terminal Description
z6-1 (U)
W
U phase motor output
z6-2 (W)
W-R
W phase motor output
z6-3 (V)
B
V phase motor output
Measure the voltage and resistance according to the value(s) in the table below.
- NOTICE:
- When the P/S warning light is illuminated due to a malfunction, the fail-safe function may cause the voltage of the power steering ECU's terminal to become 0 V.
If the result is not as specified, the ECU may have a malfunction.Terminal No. (Symbols)
Wiring Color
Terminal Description
Condition
Specified Condition
D4-1 (PIG) - D4-2 (PGND)
B - W
Power source
Always
11 to 14 V
D5-5 (IG) - D4-2 (PGND)
G - W
IG power source
Ignition switch on (IG)
11 to 14 V
z5-6 (TRQ1) - z5-1 (TRQG)
G - B
Torque sensor signal
Ignition switch on (IG), steering wheel not turned (without load)
2.3 to 2.7 V
Ignition switch on (IG), steering wheel turned to right with vehicle stopped
2.5 to 4.04 V
Ignition switch on (IG), steering wheel turned to left with vehicle stopped
0.95 to 2.5 V
z5-2 (TRQ2) - z5-1 (TRQG)
Y - B
Torque sensor signal
Ignition switch on (IG), steering wheel not turned (without load)
2.3 to 2.7 V
Ignition switch on (IG), steering wheel turned to right with vehicle stopped
0.95 to 2.5 V
Ignition switch on (IG), steering wheel turned to left with vehicle stopped
2.5 to 4.04 V
z5-4 (TRQF) - z5-1 (TRQG)
W - B
Torque sensor reference voltage
Ignition switch on (IG)
3.35 to 3.37 V
z5-3 (TRQV) - z5-1 (TRQG)
R - B
Torque sensor voltage source
Ignition switch on (IG)
8.5 to 10.5 V
z5-1 (TRQG) - Body ground
B - Body ground
Torque sensor ground
Always
Below 1 Ω
D4-2 (PGND) - Body ground
W - Body ground
Power ground
Always
Below 1 Ω
z7-1 (C1) - D4-2 (PGND)
R - W
Resolver signal
Ignition switch on (IG), steering wheel is turned
0.68 to 4.42 V
z7-5 (C2) - D4-2 (PGND)
L - W
Resolver signal
Ignition switch on (IG), steering wheel is turned
0.68 to 4.42 V
z7-2 (S1) - D4-2 (PGND)
B - W
Resolver signal
Ignition switch on (IG), steering wheel is turned
0.68 to 4.42 V
z7-6 (S2) - D4-2 (PGND)
Y - W
Resolver signal
Ignition switch on (IG), steering wheel is turned
0.68 to 4.42 V
z7-4 (R1) - D4-2 (PGND)
W - W
Resolver excitation signal
Ignition switch on (IG), steering wheel is turned
2.9 to 5.1 V
z7-8 (R2) - D4-2 (PGND)
G - W
Resolver excitation signal
Ignition switch on (IG), steering wheel is turned
2.9 to 5.1 V
D5-2 (CANH) - D5-8 (CANL)
BR - W
CAN communication line
Ignition switch off
54 to 67 Ω