2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)

  1. B164421E08
    Check the operation of the back door courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 3
      Lock
      10 kΩ or higher
      Unlock
      Below 1 Ω

      If the result is not specified, replace the back door lock assembly.


INSPECT BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)

  1. Check the operation of the back door courtesy switch.

    E151699E01

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Door Lock Latch Position
      Specified Condition
      3 - 4
      Open-latch
      Below 1 Ω
      Half-latch
      Below 1 Ω
      Full-latch
      10 kΩ or higher
      Over-latch
      10 kΩ or higher

      If the result is not specified, replace the back door lock assembly.

← REMOVAL (from Jul 2010)INSTALLATION (May 2007 – Jul 2008) →