2007-2013 Highlander Kluger · Service Manual CRUISE CONTROL SYSTEM

INSPECTION

Inspection · Vehicles built May 2007 – Jul 2008

Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 from Jul 2010


INSPECT CRUISE CONTROL MAIN SWITCH
  1. Remove the cruise control main switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    E106137E14

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A-3 (CCS) - A-1 (ECC)
    Neutral
    10 kΩ or higher
    A-3 (CCS) - A-1 (ECC)
    + (ACCEL)/RES (RESUME)
    235 to 245 Ω
    A-3 (CCS) - A-1 (ECC)
    - (COAST)/SET
    617 to 643 Ω
    A-3 (CCS) - A-1 (ECC)
    CANCEL
    1509 to 1571 Ω
    A-3 (CCS) - A-1 (ECC)
    Main switch on
    Below 2.5 Ω

    If the result is not as specified, replace the cruise control main switch.

← REMOVAL (from Jul 2010)INSPECTION (Aug 2008 – Jun 2010) →