2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built May 2007 – Jun 2010

Versions by build date: May 2007 – Jun 2010 from Jul 2010


INSPECT REAR COMBINATION LIGHT ASSEMBLY

  1. E151682E04
    Disconnect the connectors from the rear combination light assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH Side:
    Tester Connection
    Condition
    Specified Condition
    O25-1 - O25-2
    Light control switch OFF
    Below 1 V
    Light control switch in TAIL
    11 to 14 V
    O25-1 - O25-3
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V
    O23-1 - O23-2
    Turn signal switch OFF
    Below 1 V
    Ignition switch on (IG) and Turn signal switch in LH
    11 to 14 V (60 to 120 times per minute)
    O12-1 - O12-2
    Shift lever not in R
    Below 1 V
    Shift lever in R
    11 to 14 V
    RH Side:
    Tester Connection
    Condition
    Specified Condition
    O26-1 - O26-2
    Light control switch OFF
    Below 1 V
    Light control switch in TAIL
    11 to 14 V
    O26-1 - O26-3
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V
    O24-1 - O24-2
    Turn signal switch OFF
    Below 1 V
    Ignition switch on (IG) and Turn signal switch in LH
    11 to 14 V (60 to 120 times per minute)
    O13-1 - O13-2
    Shift lever not in R
    Below 1 V
    Shift lever in R
    11 to 14 V

    If the result is not as specified, there is a malfunction on the wire harness side.

← COMPONENTS (from Jul 2010)ON-VEHICLE INSPECTION (from Jul 2010) →