2007-2013 Highlander Kluger · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from May 2007


INSPECT LICENSE PLATE LIGHT ASSEMBLY

  1. E147809E02
    Disconnect the T2 connector from the license plate light.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    T2-1 - T2-2
    Light control switch in TAIL
    11 to 14 V
    T2-1 - T2-2
    Light control switch OFF
    Below 1 V

    If the result is not as specified, repair or replace the wire harness or connector.

← DISASSEMBLY (from May 2007)REASSEMBLY (from May 2007) →